Caution: Insertion tools can be used for third party company.
(However, recoil and outside diameters are slightly different, so tools made by recoil companies are not suitable.), Purpose: Regeneration and strengthening of female screws. Used for fixing and regenerating damaged screw threads, and for screwing into light weight material such as plastics and light alloys, such as various types of machinery, airplanes, cars, bikes, etc., Material: SUS 304
Caution: Tang snapping tool, sprue release tool are not included in the contents of the set., Size: M3-0.5, M4-0.7, M5-0.8, M6-1.0, M8-1.25, M10-1.5, Set Contents: ? Sprue... pieces each 10
-play winder, mandrel... each 1
-Tap... each 1
-Tap... each 1
-Mandrel sleeve... one
handle... each 1
-cap... each 1
-Retaining rings: 4 pieces
Caution: At the time of pulling out the coil of blind hole thread, cut it up to blind hole thread size and use Please grind it little by little at the time using the grinder.the front tip is heat treated There is risk of cutting the material with electronic, Size: M3-0.5, M4-0.7, M5-0.8, M6-1.0
(untill unified size No4-40 to No10-24 applicable), Usage: 1. With handle or tap handle, make edge of coil insert out a bit. 2. Setting the electromotive driver to opposite revolution, turning slowly at low speed, and pull out.
Caution: Because it is made to use the tap handle, at the time of insertion the handle does not come off from the mandrel without getting fixed in mandrel., Usage: 1. Make up the tang of coil insert and set in the mandrel 2. Insert in the sleeve after putting up the point of the mandrel. 3. Until the tip of the mandrel comes out a little, please turn and insert the sleeve.(Please do not put out until the point of coil insert) 4. When you adjust perpendicularly into the core of the tap hole of the other working part inserted, hold lightly and turn the steering wheel to the right. coil insert is inserted.(When turning the steering wheel to the right, please do not push the steering wheel.It causes a bad insertion with a flying pitch)
Caution: This product is manufactured in Japanese standards. Please check the specification before you order., Nominal Designation of Screw: #8, Freedom Minimum Outer Diameter (mm): 5.21, Freedom Maximum Outer Diameter (mm): 5.59, Under Tap Hole Minimum Diameter (mm): 4.33, Under Tap Hole Maximum Diameter (mm): 4.52, Number of Threads: 32, Number of Free Coils: 3 1/2, Pitch: 0.793