Engine oil change at home
On 2019-10-29 00:24:19
Opened for oil change
The suction nozzle you want to use breaks in the middle
I couldn't work.
On 2019-06-30 18:06:19
It's bothersome to jack up a low profile car.
It is a machine that solves such troubles.
There is a review that the part of the air coupler is easy to be damaged, but if you use two spanners and work firmly, there is no concern about the damage.
After that, it is necessary to work with care so that excessive force is not applied from the air hose.
Motorcycle oil change
On 2019-04-04 12:54:59
In recent mopeds, there are vehicles where the oil drain is too close to the stand and it is difficult to place the oil tray. In that case, there is no problem in the suction place with this device. It is useful because there is no left over.
For car maintenance
On 2019-03-09 09:58:25
It was not possible to use it because the nozzle did not go down to Suzuki's light four. I think that it is good because it was able to use for the Toyota car. It was good to see the amount discharged at a glance and the amount to be refilled easily.
Oil change of private car
On 2018-12-29 18:54:44
Although other people are also writing, since the female metal fittings of air are attached in the form embedded in the main body, it is easy to break, so when attaching male fittings wind the air tape and hold both metal fittings tightly with a wrench and install it I think that it can be used without problems.
I am using it with air, but I told you that it is enough from about five minutes to fully extract 4L.
The product itself is very satisfied.
Own owned vehicle oil change work
On 2018-05-15 16:59:22
I used it for 10 vehicles, a fork, a Yumbo total of 10 vehicles used for oil change of my company's vehicle and machine, but only one nozzle did not enter. And since suction speed is a little slow (nozzle can not be helped because it is thin, but ... ...) It takes a lot of time compared to bleeding.
Automobile oil change
On 2017-12-15 17:12:44
Others also had a review that the air - regulated valve had broken. I thought that there was no replenishment part so I could replace it with a screw type immediately. I was also broken, it is necessary to prepare replenishment parts if it is fragile There is nothing, it will not be useful without this part, what to buy again? What? I want you to prepare by all means
Agricultural machinery that is difficult to extract oil, such as withdrawal of gasoline
On 2017-11-23 15:15:26
It is easy to extract with various hoses. If you can make discharge easier a little (without pulling out the hose)
Oil change · tank cleaning
On 2016-11-29 21:58:59
Things that used to be used earlier are not useful as early as bruising such as shaft plating, but this product is also easy to use well. Is there a replacement part setting, although the one way valve where it pulls out with air is damaged?
During oil change
On 2016-09-08 01:06:52
I think that it can be used for most passenger cars. I think that the truck can be used almost if it is a so-called 2t car class. I am using air to pull out, but it is very handy. However, please think that the hose is a consumable part. When it gets scratched, it breaks inside and gets caught out very hard.