Manufacture of pilot bearing puller
On 2019-07-20 09:57:41
It was not just iron, but it was SCM 435 of chromemolybdenum steel. (With floating letters displayed on the hexagonal head)
It was necessary to make a pilot hole of φ 5.0 at the center of M16 bolt and set up M6 female screw according to the application, but it turned out that it is a considerably hard material with high strength.
On 2019-07-08 13:49:05
I used a normal bolt, so I could buy it and use it with no problem because it was deformed in some places.
As a motor adjustment screw
On 2019-03-23 08:47:45
Used to adjust the V-belt tension of the drive motor. If it becomes about 100mm in length, it is saved because it does not sell very much at the store. The price is not right ...
Used as adjustment push bolt for fixed blade of grinding machine
On 2019-02-26 16:36:42
When we used with general screw, we were crushed and replaced it with this screw. It can be used without problems now. All screw bolts with a strength category of 12.9 would still be helpful.
Used to remove the motorcycle crankcase
On 2017-11-29 22:20:35
Used to remove the Skywave crankcase.
Because I needed the M8 long bolt.
When parts of the product are out of stock
On 2017-05-11 11:33:13
The handlers were very sized because it was a small bolt size. I will appreciate it in the future because I can save the trouble of finding a merchant!
Used for heavy machine frame
On 2017-02-06 00:54:58
There are many types, length and so on so we are very saved.
On 2016-02-23 15:44:33
I was saved because I was looking for long screws of all screws with high tension.
Car parts High lift
On 2016-02-16 08:52:51
It is a very appreciated product because it was hard to find all screws with a pitch of 1.25 with a high tension of 10.9.
On 2014-08-14 13:25:41
With 10.9 all screws, UNIQLO is unusual, so it is saved.