To replace the Shoboi clutch shoe of the Tamiya engine radio control with the Kyosho KC-45 special clutch shoe
On 2019-03-28 13:20:13
Since the pin attached to Tamiya's fly foil is short, I grabbed it with a radio pliers from the back side and struck it with a hammer.
The carbon clutch shoe was attached nicely and the acceleration of the radio controlled car was up.
Pruned scissors women's
On 2018-11-19 18:09:03
It was possible to prevent the pin from being disconnected due to work and interrupted afterwards.
You can work safely.
To prevent deviation of the device
On 2018-10-29 15:48:18
Strength is satisfactory enough without problems. I also want to repeat.
Movable shaft of plastic products
On 2017-06-30 16:16:30
Although it is a small size, but the accuracy is good, even if you leave a gap, you can use it in the same way and it will be saved.
As RC drive shaft pin
On 2016-09-09 14:14:14
It is 1/10 buggy. I expected the phrase hard, but I ran away from 2 to 3 packs (less than 1 hour) with a battery, about 1/4 shaved. It will decrease to the form of D. After that, it is problem solving as pin of infinite precision machine. I wanted 10 mm, but it did not matter if it did not hit the surrounding even with 11.8 mm.
On 2016-08-01 08:55:08
Where you can purchase in small lots is good, is not the fare cheap?
Specifications fixed pin
On 2015-09-26 13:16:43
It was able to be used without problems without problems or defects.
Fabrication of screws
On 2015-03-19 17:05:41
I would like to add items that are more soft and easy to process.
On 2014-11-14 15:32:01
The product accuracy is stable and good. We would like to reduce the cost by 100 units, 200 units.
To the pin of the belt buckle.
On 2014-04-24 16:35:24
Purchase of belt buckle pin, because it was missing and could not be found. Because it was between 2.0 mm and 1.6 mm in size, it was scraped off with metal file for metal and managed to fit in the hole. I bought it and was right. Thank you very much.