Fixed as various devices, used as a feed screw that does not require accuracy
On 2019-06-25 21:26:19
Screws are limited to domestic production ... well, but there is no complaint.
There are no cracks or cracks in the metal, no tapping on the tapping, no bending on the bottom.
Above all, a nut goes straight from the beginning to the end ....
It's a matter of course, but it's a big deal, but I once again felt the gratitude of certain quality.
On 2019-06-15 19:43:08
I think that neither precision nor surface treatment can be said, but the price is high. If it is a little cheaper.
On 2019-02-23 12:16:14
Self-made this, first I purchased and processed. I can only sell people who have the same length with a reverse threaded intermediate nut, but I know only people who understand it,
Optical axis adjustment
On 2019-02-05 14:32:55
It did not have any problem.
It is fine without rusting so far.
cx-5 To make rear stub link of KE
On 2019-01-15 08:02:11
I installed it in a vehicle whose car height was dropped.
From the driver, the feeling became mild and the feeling that the stabilizer is working
Used for fastening wood parts
On 2019-01-14 06:43:50
I am satisfied with high processing precision. I would like to continue to use Monotaro in the future.
Pillow ball joint
On 2018-12-25 14:57:29
I used it as a rod connecting the pillow ball and the pillow ball of the automobile stabilizer. It was able to be used without problems in particular. I needed two, but it was good because it was just two.
On 2018-10-22 19:14:42
Although making is very good, 35 mm was my mistake without looking properly from the thought that it was 350 mm.
Production of research equipment
On 2018-06-24 18:45:25
It was saved because there was no stain cutting bolt of this length in the neighborhood home center. Quality is satisfied.
Used for machine maintenance
On 2018-05-02 21:03:45
I make it to the shaft of my own slide hammer to use during maintenance.
There is also strength and processing of the tip is also beautiful.