Tonearm cartridge shim
On 2019-08-05 18:59:11
To fix the cartridge attached to the tone arm, t0.25mm and 0.50mm cannot be installed unless the ring part is opened at the time of purchase installation.
It is just good hardness.
Record player tone arm spacer
On 2019-07-15 22:04:21
Purchased t0.25 and t0.50 as a record player's tone arm spacer.
Since it can not be used if it is as it is, insert a cut with a knife and use it.
The hardness is GOOD.
As an alternative to a genuine bike
On 2019-02-15 10:05:10
Purchased instead of the plastic washers used on the MV Agusta bike screws. It is the same thickness and size as genuine parts, but the price is much cheaper (genuine 108 yen / piece → 11.6 yen / piece), so it is recommended.
For bath hinge hinge
On 2019-01-12 17:50:02
As the tip of the door began rubbing against the frame, when trying to remove the hinge the existing resin washer was considerably thin. Originally I was wondering whether the frame was distorted, but apparently it was caused by the fact that the position of the door was lowered due to the wear of the washer.
Various sizes can be specified with inner diameter / outer diameter and it will be saved.
On 2018-11-13 21:25:08
For extremely small volume and small volume products we would like to deliver in envelopes.
Adjust the door height with a hinge
On 2018-01-20 15:41:06
The more frequently used doors, the lower the way it goes down, so procure it by considering the wing of the hinge spacer. Since the amount of wear was different for each door, it was convenient to adjust the thickness by adjusting the number.
Used as a guitar part
On 2017-11-03 01:58:10
In standard products like JIS, there are tolerances and large play
It has a large outside diameter and it looks bad, but this is just
Moreover, although it is used for the sliding part, it feels smooth.
Because it is a resin, oil is unnecessary.
For motor bearing replacement
On 2017-10-21 09:56:01
I bought it for use between the shaft and the bearing. I wanted something with more thickness. I think that it is good as a substitute item.
Coupler air leakage repair
On 2017-09-01 17:19:39
From air coupler made in China
There is air leakage, and this slider
I could use and repair it.
On 2017-02-28 13:25:00
Since the outer dimensions are almost the same size as the cap bolt diameter, there is no overhanging like a usual washer and you can see clearly. It's fairly thin, so I use four piles in a row.