On 2019-08-05 09:56:33
Since each size was written at the examination, I changed it with peace of mind.
Toy gun custom
On 2019-06-26 23:19:52
We purchased to make captive around the recoil spring of KSC made M93R2 (cis 7).
The guide body uses Vertek's (plastic cross-shaped guide),
The diameter of the guide tip is 7 mm, set the spring first,
If you force-in this M6 washer,
Since the washer will be caught on the step of the guide tip,
You can set so that the spring does not fly away.
When disassembling, it is possible to prevent the spring and guide from becoming "Beyondtsu !!",
It is very useful because there is almost no need to hold back the spring when installing.
However, although the diameter of the hole in the washer is 6.5 mm, it is slightly narrow when actually trying to insert it.
It needs to be spread a little with lute and files.
The stroke of the slide will be shortened but there is no big deal
The slide stop also hangs properly.Because it is a resin washer,
It also has the effect of slightly reducing the impact of blowback and prolonging the life of the slide.
By the way, because the spring pressure is strong in the 93R model gun
This method did not work (the washer is pushed out and comes off)
I think it would be out of place if I used it,
As this washer of Monotaro comes in 34 packs, too,
It is safe just to replace if it becomes a failure.
Screw fixing to the wall
On 2019-03-27 08:44:47
I thought it was a softer elastic material because it was nylon, but it was as hard as plastic.
Resin, carbon parts, low voltage insulation etc.
On 2019-03-24 18:36:52
We purchased with polycarbonate washer. In order to use properly according to the place to use,
Useful. Low voltage is useful because it can be used as an insulation washer.
In fact, I saw selling it as an insulating washer, so I became the deciding factor in the purchase.
Used for fixing plastic.
On 2019-03-06 15:55:36
As it is a place where it vibrates, it was used because it would be scraped with a metal washer.
There is no problem in particular.
On 2018-10-05 14:45:07
The monoterror washer is cheaper than the other though the quality is good
It is greatly saved by material cost reduction
As a substitute for spacers
On 2018-06-29 15:16:01
It is used as a substitute for the spacer where strength is not needed.
Since the thickness is exactly 1 mm, it is used as a substitute for the spacer by stacking necessary number of sheets. It is light and cheap.
Fastening of plastic material
On 2018-02-12 19:36:23
Especially not possible but not impossible, but there is no neighborhood home center so it is purchase.
I think that it is good for materials that you do not want to hurt.
On washer for oil seal of propeller shaft of water bike
On 2017-12-18 17:20:06
It was used as a washer for lining of the oil seal. I did not import it from the United States just feeling good and it was saved.
Use it variously
On 2017-11-23 00:47:17
It was cheap, it was good. The goods are also properly decorated. I want to buy it again when it runs out.