訂單總金額超過 * S$200* 免運費

(+)盤頭自攻螺釘(聚醯胺樹脂高強度尼龍)(包裝品)

4.20 (5)
Material
Lenny (high-strength nylon)
...查看全部>
商品選項
加入購物車
Length (mm) Pitch Nominal Designation of Screw Package
Qty.
Ship pack of Mfr.# Item.# 銷售價格 Availability 數量
Length (mm) Pitch Nominal Designation of Screw Package
Qty.
Ship pack of Mfr.# Item.# 銷售價格 Availability 數量
8 0.7 M4 1Pack(7PC) 1 4x8 42177737 6.49 SGD
In stock
8 0.5 M3 1Pack(9PC) 1 3x8 42177721 6.49 SGD
In stock
10 0.7 M4 1Pack(7PC) 1 4x10 42177746 6.49 SGD
In stock
加入購物車
顧客評價
5 星 4
4 星 0
3 星 0
2 星 0
1 星 1
好評率: 4.20
5 顧客評價
顧客評價由穀歌基於日文自動翻譯
Scooter, car weight reduction
5
From Japan
On 2019-02-13 15:35:41
I replaced it with an aluminum screw so far to reduce the weight of the 4mm tabbing iron screw that is often used in moped scooters, but I made this screw lighter than an aluminum screw. If so, you can tighten it normally. This lightness is addictive. If possible, I also want a lineup of truss heads and 4x15.
This review is about item#42177746.
In a wooden box
5
From Japan
On 2018-11-15 15:20:26
It is rusty because it is made of resin The strength is enough, Renee is afraid.
This review is about item#42177721.
Assembling the control panel
5
From Japan
On 2018-02-20 19:50:34
Because plastic tapping screws are rare and hard to get into It was saved.
This review is about item#42177737.
Bonding between resins
5
From Japan
On 2017-08-08 17:47:50
Since this product is a tapping screw, it is unsuitable for the hole where nuts and taps are cut, of course. Also, it will be impossible for metal partners. In my case I used it for joining ABS plates but I think there is sufficient strength. It seems that the preliminary hole is 3.3 mm (same as the M4 parallel thread). By the way, because the unthreaded end of the tip was 3 mm, I tried to tighten it with a 3 mm pilot hole, and it was threaded halfway through. From this, I feel it is hard and brittle compared to polyca thread. (It does not mean there is no strength)
This review is about item#42177737.
Base stopper
1
From Japan
On 2017-01-07 11:24:33
It does not match the nut with the same M3 pitch 0.5. I do not enter at all.
This review is about item#42177721.

相關商品