On 2019-03-26 14:44:13
I am planning to buy it again because it is very good for cospa.
On 2018-12-03 07:33:52
I bought it with a material, but the number of packs is too large to use out ... I thought that it was good to reduce the amount cheaply.
On 2018-08-14 19:39:31
I used it as a plug of the oil drain of the motorcycle. I think that it is better because it is cheaper than purchasing genuine parts.
Used for oil line of motorcycle engine
On 2018-05-30 15:39:52
I was looking for something that was perfect for sizing. I found it in the catalog and ordered immediately, the next day I was able to finish the repair.
On 2018-05-01 12:34:31
Used as a spacer when diversion is made outside the back step, it is good to avoid light rust as it is aluminum.
On 2018-03-18 22:34:03
It purchased with drain packing of engine oil for GPX 250 R. I think that you can use it for many different types of vehicles.
Set with aluminum bolt
On 2018-03-03 22:24:56
As a measure against rust prevention of the bolt of the motorcycle, the bolt which does not apply load is changed to aluminum. Once the bolt is made of aluminum, the washer will also be aluminum.
However, it contributes little to weight saving. The reason is that the original washer is light even if it is iron.
There is no problem in terms of quality, as tightening torque is not excessive. Because it contains a lot of quantity, I do not feel as high as aluminum bolt.
Maintenance of motorcycle
On 2018-01-31 22:03:50
We sometimes change bolts and nuts that do not load due to weight reduction of the bike and rust preventive measures to aluminum. Lightweight items such as washers are rarely used for weight reduction, but as a measure against rustproofing, they are exchanging simultaneously.
Oil drain bolt washer
On 2018-01-13 12:47:39
Because there is no quality indication, I thought that it was O material but purchased it was H material.
But this is obviously a mistake in my judgment.
Used as oil drain washer of 2st Vespa.
On 2017-11-17 22:56:21
Since the oil drain washer of the 2nd Vespa is 7 mm, it is used by cutting with a ruther and using it.
There is no oil leakage and cost can be saved.