As the shaft of a screen door car
On 2019-05-25 22:02:13
The plastic shaft of the screen door car was damaged, so it was purchased as a repair part.
In order to attach an E-shaped retaining ring to the tip of the rivet, I decided to dig a very thin groove with a lathe.
I was expecting that the material of the rivets would be stainless steel, which would make the processing extremely difficult, but the stainless steel of SUSXM7 was surprisingly soft and the grooves could be easily dug. I am very happy.
Repair of agricultural tools
On 2019-01-23 20:16:57
The rotor pin of the agricultural tool was bent, so I purchased it as a substitute. I opened the hole and attached it, but for the time being it seems to be usable. I am thankful that the products I didn't put in any home center had a reasonable price.
Used to fix indicator on iron plate
On 2018-10-23 19:14:30
Screwdriver, bolt / nut fixation work easier, best suited for parts not tough!
For machine maintenance and repair
On 2017-06-13 18:02:03
Please order 8x20. Although it can be used by shortening it with a grinder, thank you. Although it does not say for the time being ,,,,,,,,,,.
For Tamiya's basic compressor repair
On 2017-06-10 17:36:54
When Tamiya's basic compressor is in use, noises are emitted from the inside and the pins disengaged from the crank of the motor part when it is scattered, as soon as it is returned to the original and it is repeated again, the pin comes off The symptoms that stopped stopping did not stop. The bellows of the compression unit is still almost undamaged, and I searched with Monotaro to see if there is something that can be dealt with cheaply and found this rivet. Originally used pins were straight straight pins without head umbrella parts, so it seemed that they could come out as soon as a load was applied. Although it was press-fitted, it felt like I could get out quickly with the power of a person. Also I felt that the length was insufficient, so this time I ordered something a bit longer (original 20 mm ordered against 16 mm). It hits this and it works without problems at all with the pin coming out. Although I thought whether to buy another compressor even though it is second hand, it costs thousands of yen, and it got a considerable saving by just replacing it with this rivet. I think I will use it until it breaks.
On 2017-05-02 14:29:08
From the price, it is kind of what I was satisfied with.
Used as a support for a roll bearing of a plastic costume shelf (major furniture chain)
On 2017-03-01 05:42:19
Tog Bearing (TOK) DR - H (Standard Type) TYPE 2 DR - 19 - H5 was used together. This rivet was 5 mm in diameter as a bearing pillar, which was optimal because it is not hollow even if riveting is mentioned. However, since the hole for inserting the original bearing part of the plastic shelf is slightly wider, it will come off as it is, so after inserting DR-19-H5 above, wind the cellophane tape one turn around the rivet support and then into the hole I inserted it so as not to come out. The bearing parts that came with the plastic shelf were fragile, so repairing like this in the future will likely be usable for a long time.
Replacement of corrupted rivets on accordion door.
On 2015-12-16 16:22:44
Accordion gate rivet is made of thin aluminum, easily damaged due to aged deterioration. I attempted to repair with tapping screw, but it did not result satisfactory. Therefore, make the tip of this product tapered, press fit with Sako Vice. Fixing is sure. It is made of stainless steel, also safe for rust.
On 2015-07-06 18:23:09
I am pleased that I can easily purchase what I was looking for.
Repair of leather goods
On 2014-03-17 18:11:43
It's pretty good.