Other Pliers

Speedy pliers work that is ideal for attaching and detaching E-rings

A board anchor tool that can be used widely from DIY to professionals!

A special tool for efficiently attaching and detaching the double ring! Since the main body uses special carbon steel, the installation work of the tough double ring can be done easily.

Speedily bind wiring. Tighten and cut the wiring with this one.

The structure allows the ring to open with a single touch.

With a spring that is convenient for opening key rings and double rings. It can also be crimped and cut. You can use it not only for making accessories but also for fishing. * Only soft wires such as aluminum wire and copper wire.

The best pliers for attaching and detaching the E-ring. Work can be done speedily. It has a glossy polishing finish.

For bending lead wires of electronic parts (resistors, diodes)! With soft cover and spring For bending lead wires.

A special tool for efficiently mounting the E-ring! The main body uses special carbon steel, so it is tough For mounting the E-ring attached to the shaft of precision equipment

The very small head makes it ideal for tighter spaces. Since the release lever is on the top of the handle, there is no bounce and it is easy to use. Ideal for holding two flat panels on top of each other. Sheet metal work such as positioning, bending, crimping, and straightening of sheet metal j... Read More

It is a plier that opens in parallel, which is unlikely. An excellent product that bites parallel to the thickness of wires and iron plates. It has a groove. ○ Ideal for grasping shapes. There are grooves in the vertical and horizontal directions.

The tip is rounded and thin to make it easier to enter narrow spaces. A special tool for pulling tire nails.

The head is shaped so that it can be firmly grasped at three points. Since the release lever is on the top of the handle, there is no bounce and it is easy to use. Ideal for spot welding two flat panels. Sheet metal work such as positioning, bending, crimping, and straightening of sheet metal joi... Read More

A new type of pipe pliers that can be widely grasped. A one-push adjustment is used to enable fine adjustment in 25 steps. It is sturdy and can withstand high loads. Suitable for tightening and loosening deodorant valve connection screws, plastic pipe fittings, round nuts, etc. Gently remove the ... Read More

For breaking glass along narrow cut lines. Ideal for finishing the edges of glass. Very sturdy due to forging. The material is special tool steel that has been oil-quenched and tempered.

You can grab a retainer ring with a minimum diameter of Φ12 to Φ20 mm. The retainer hidden in the hub can also be attached and detached.

For crimping U-shaped contact single scotch connectors for telephone lines or signal cables. The U-shaped part removes the coating, so stripping is not required. The side cutter has been carefully hardened. With an open spring, you don't have to open your mouth for repeated work. The material... Read More

The small head makes it ideal for narrow spaces. Since the release lever is on the top of the handle, there is no bounce and it is easy to use. Great for holding two flat panels of the same thickness. Sheet metal work such as positioning, bending, crimping, and straightening of sheet metal joints.

You can notch plastic shelves and cases for electrical and sanitary plumbing work. If you want to increase the notch range, you can do the notching in two steps. The cut surface is beautifully finished, so there is no need to reshape it. With a design that makes the best use of the principle of l... Read More

Structure that opens the ring with one touch (PAT.P)

Bicycle pliers with features such as outer casing and end cap caulking

Adjustable screw tool heads Smooth jaws allow surface-processed fixtures to be mounted without damage. Adjustable screw tool. Very suitable for gripping, holding, compressing and bending workpieces. The playless flat jaw does not damage the edges even with fragile fixtures. It can be adjusted by ... Read More