Pin Headers

It is a type of wrapping terminal connected at a pitch of 2.54 mm. The switch can be switched in combination with the jump socket (product number JS-1). In this case, the height from the printed circuit board surface is 6 mm. (Combination of WL-1 and JS-1)

A plug that fits the socket. Please use by soldering and crimping the electric wire to the plug.

Please use it when supplying power to the surface mount board.

Please use when attaching electric wires such as GND line and signal line.

Please use it when you attach it to the panel and check the signal line. The probe of the oscilloscope can be hooked. Since the terminal is retracted to the back, it can be used safely because it does not touch the hand.

It is a pin that becomes the foot of H.IC. Please attach it to the printed circuit board and solder it.

A pin that can be erected on a surface mount board. The DHS series can be positioned.

It is a socket, and OP-7-1, OP-7-2, OP-7-2-100 (with electric wire) are suitable for the male side. A socket is also prepared on the opposite side (1.0Φ side), and OR-5-3 and OR-5-3-50 (with electric wire) are suitable.

HWP-2P, 3P series with longer pins. The specifications are the same as the HWP-2P and 3P series.

This product and the housing (OH series) are paired. This product alone (without housing) can also be used. Use the OM series crimping tool (OMXT-1) to crimp.

It is a check terminal that can be hung on the chip mounter. The size is 1.2 x 1.0, which is extremely small, making it ideal for small devices. Use the oscilloscope probe by hooking it into the hole inside. When reflowing with normal cream solder, the strength will increase if the land shape is ... Read More