DIY Maintenance work
On 2017-10-06 09:45:47
I bought it to the wheel stopper of the garage. Since the floor is concrete, I pasted it with an adhesive, but it is okay.
Garage tire stop
On 2017-09-06 19:08:04
The anchor diameter is 10 mm. Drill diameter is required about 10.5 mm. The seismic intensity drill for home is a tiresome diameter. After driving the anchor, it is necessary to fix with a punch-shaped tool. It is also necessary to tighten the bolt with a socket wrench. I could fix it enough.
Parking lot parking lot
On 2017-09-06 16:58:43
Functionally there is no problem at all Anchor bolt and bolt cap are also attached and I think that it is affordable But as soon as I remove the tape attached to the product, I will ask for improvement
Used for garage
On 2017-09-03 09:04:13
For now it will secure the tire firmly.
There are 12 mm pilot holes, but it was too large at 12 mm.
Thanks to that, we could not secure the body firmly.
On 2017-05-31 08:56:12
I purchased it because I thought that older people falling down and making head injuries should not cause serious injury.
As a stop.
On 2017-05-23 00:25:09
Since there are burrs on the outer circumference on the ground plane side and it is decocted, a gap can be formed by grounding it on a flat surface. Although burrs can be easily cut with a cutter, since thin wires are in place in some places, they have to be cut with nippers. Nevertheless there is warpage so do not touch it exactly. However, it is a part that can not be seen, and it will not be known if it is fixed with bolts.
Use for parking lot
On 2017-05-03 10:44:20
Since it is made of rubber, I bought it as if there was no damage to the tire even if I hit it vigorously. I asked the installer to install.
Change of parking position accompanying scaffold assembly
On 2017-03-29 17:22:59
The attached asphalt nail, which was more robust than imagined, is so soft that it is necessary to drill a prepared hole
Used in the parking lot of the house
On 2016-11-19 20:19:24
Always used to put it in the parking space with back. Since our parking space is narrow, our house is installed so that about 10 cm from the outside of the main body meshes with the tire. Therefore, it can not back with fluorescent reflection display as a marker. If you can freely change (change) the label position of fluorescent reflection display, I think that it is more convenient to use. The function of securing the stop position of the car is satisfactory enough
Maintenance of the house
On 2016-10-09 11:16:56
Even if my wife entered the garage, I could not hit the bumper, so I wish I had bought it sooner.